This is a 14' jon boat with free hand camo painted over factory green paint. No electric, use flashlight type running lights fore & aft that c-clamp to the transom and a aluminum block I installed on ...
This is a 16 ft mod-v hull by Alumacraft. There is an added wood floor/carpeted that meets the front deck which has an added 18" to the metal deck to allow for adding a front swivel seat and a storag...
I use the boat for pleasure, fishing and duck hunting. It is a 19 foot alumaweld with a inboard jet drive. It will plain in 6" of water and at rest it needs about 1 foot. For the blind I went with st...
Excel 1851 F4 edition 0.125 hull powered by a Mudbuddy 35 CDI Hypersport with stainless exhaust, BPS heads, and Mikuni Carb. Did some paint, hydroturf, LED running lights, and modified the dual LED s...
The Bad Habit is made from an old low profile speedboat. It has interior rope lights, halogen running lights,
carpeting, swivel seats, and is fully waterproof. It comfortably hunts 3 guys and ea...
started off with a plan jon boat i mostly hunt on rivers that are only like a foot deep so i put outboard jet on the back then i made a little pop up blind with fast grass but it was a lot of wo...
The MotherDucker is a G3 1860 Mod-V Style Jon Boat. When I picked her up late last summer (09), she had no blind on her. Spent the late summer and early fall designing and building the blind. The blin...
We either take the boat or the canoe depending on the spot. Both are towed by the duck truck. We made the camo out of baling twine tied too strips of chicken wire. This took three guys 4-5hrs to make,...
